Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1429 (ELECTRONIC ENGINE CONTROL)REMOVAL AND INSTALLATIONCYLINDER HEAD TEMPERATURE (CHT) SENSOR
2009 Mercury Milan Premier, 3.0 1, AWD
Cylinder Head Temperature (CHT) Sensor
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Cylinder Head Temperature (CHT) Sensor
WARNING: This page is about a different car, the 2009 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Cylinder head temperature (CHT) sensor electrical connector |
| 2 | 6G004 | CHT sensor |
- Remove the lower intake manifold. For additional information, refer to ENGINE - 3.5L article.
- Disconnect the cylinder head temperature (CHT) sensor electrical connector.
- Remove and discard the CHT sensor.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Do not reuse the CHT sensor, install a new sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.