SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1417 (AUTOMATIC TRANSMISSION EXTERNAL CONTROLS)GENERAL PROCEDURESSELECTOR LEVER INDICATOR ADJUSTMENT
2009 Mercury Milan Premier, 3.0 1, AWD

Selector Lever Indicator Adjustment

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Selector Lever Indicator Adjustment
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower steering column opening finish panel.
    1. Remove the screw and position the parking brake release handle aside.
    2. Remove the screw from the lower steering column opening finish panel.
    3. Pull outward to release the retaining clips and remove the lower steering column opening finish panel.
    2. Fig 1: Lower Steering Column Opening Finish Panel
    GF0014148Courtesy of FORD MOTOR CO.
  2. Remove the 5 screws and the lower steering column opening finish panel reinforcement.
    3. Fig 2: Lower Steering Column Opening Finish Panel Reinforcement
    GF0014149Courtesy of FORD MOTOR CO.
  3. Rotate the selector lever clockwise until it bottoms out (1st gear), then rotate it counterclockwise 2 detents (Overdrive (Circle D) position).
  4. Hang a 1.4 kg (3 lb) weight on the gearshift
  5. Rotate the thumbwheel to center the selector lever indicator in the middle of the Overdrive (Circle D) position.
    6. Fig 3: Selector Lever Indicator Thumbwheel
    GF0014150Courtesy of FORD MOTOR CO.
  6. Remove the 1.4 kg (3 lb) weight.
  7. Rotate the selector lever into each detent to verify that the selector lever indicator matches the selected range. Readjust, if necessary.
  8. Install the lower steering column opening finish panel reinforcement.
    9. Fig 4: Lower Steering Column Opening Finish Panel Reinforcement
    GF0014149Courtesy of FORD MOTOR CO.
  9. Install the lower steering column opening finish panel and parking brake release handle.
    10. Fig 5: Lower Steering Column Opening Finish Panel & Parking Brake Release Handle
    GF0014151Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.