Compressor To Condenser Discharge Line: Notes

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Notes
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
Material

Item Specification
PAG Refrigerant Compressor Oil (R-134a Systems)
YN-12-D
WSH-M1C231-B
Fig 1: Exploded View Of Compressor to Condenser Discharge Line With Torque Specifications
GF0014387Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W520413 Condenser inlet fitting nut
2 12B637 A/C pressure transducer electrical connector
3 W520413 Compressor discharge fitting nut
4 19972 Compressor-to-condenser discharge line
5 19B596 O-ring seal and gasket seal kit (2 required)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.