Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1306 (INFORMATION SYSTEM & ENTERTAINMENT SYSTEM)DIAGNOSTIC TESTSINFORMATION AND ENTERTAINMENT SYSTEMINSPECTION AND VERIFICATIONAUDIO CONTROL MODULE (ACM) SELF-DIAGNOSTIC MODE - WITHOUT NAVIGATION
2009 Mercury Milan Premier, 3.0 1, AWD
Audio Control Module (ACM) Self-Diagnostic Mode - Without Navigation
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Audio Control Module (ACM) Self-Diagnostic Mode - Without Navigation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To enter the ACM self-diagnostic mode, the audio system must be on and in radio tuner mode.
- To enter the following tests, press the desired preset button while in the speaker walk-around test.
- The self-diagnostic mode has the following functions available:
- Preset button 1 = On-Demand Self-Test. This button runs the on-demand self-test.
- Pressing the MENU DOWN button allows scrolling of any DTCs found during the test while in this menu.
- Preset button 2 = Display Continuous DTCs. This button enables viewing of any continuous DTCs that have been logged.
- Pressing the MENU UP button allows scrolling of any DTCs while in this menu.
- While continuous DTCs are being displayed, pressing the EJECT button will clear all present DTCs. The key must be cycled OFF, then ON, to permanently clear DTCs.
- Preset button 3 = Signal Strength Test. This button displays the signal strength.
- Preset button 4 = Software Version Display. This button displays the ACM software version.
- Pressing the MENU UP button allows scrolling of all audio subsystem software versions while in this menu.
- Preset button 5 = Display Test. This test illuminates all the display segments for 5 seconds, then either turns all segments off or indicates DISPLAY TEST on the screen.
- Preset button 6 = Configuration Status. This button enables ACM configuration status.
- Pressing the MENU UP button displays the ACM part number while in this menu.
- Preset button 1 = On-Demand Self-Test. This button runs the on-demand self-test.
- To exit the self-diagnostic mode, turn the key to OFF or turn the audio system off.
- If the concern remains and the fault is not detected, go to Symptom Chart .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.