Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1281 (HVAC CLIMATE CONTROL SYSTEM - GENERAL INFORMATION & DIAGNOSTICS)GENERAL PROCEDURESAIR CONDITIONING (A/C) SYSTEM FLUSHING
2009 Mercury Milan Premier, 3.0 1, AWD
Air Conditioning (A/C) System Flushing
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Air Conditioning (A/C) System Flushing
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| A/C Flush Adapter Kit | 219-00074 or equivalent | |
| A/C Flush and Purge Fitting Kit | 219-00024 (part of 219-00023) or equivalent | |
| A/C Flush and Purge Machine | 219-00022 (part of 219-00023) or equivalent |
Material
| Item | Specification |
|---|---|
| A/C System Flushing Solvent YN-23 |
- |
| PAG Refrigerant Compressor Oil (R-134a Systems) YN-12-D |
WSH-M1C231-B |
WARNING:
Use extreme care and observe all safety and service precautions related to the use of refrigerants as outlined on refrigerant tank and on recovery and charging equipment. Failure to follow these instructions may result in serious personal injury.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.