Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1201 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL AND INSTALLATIONCLOCKSPRINGNOTES
2009 Mercury Milan Premier, 3.0 1, AWD
Removal And Installation: Clockspring: Notes
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Notes
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 3530 | Upper steering column shroud |
| 2 | 14A644 | Clockspring |
| 3 | - | Clockspring wiring retaining clip (2 required) (part of 14A644) |
| 4 | - | Clockspring electrical connector (part of 14A644) |
| 5 | 3F609 | Tilt wheel shank handle |
| 6 | 3533 | Lower steering column shroud |
| 7 | - | Lower steering column shroud screw (3 required) |
| 8 | 44F08 | Steering column opening lower finish panel |
| 9 | - | Steering column opening lower finish panel reinforcement bolt (6 required) |
| 10 | - | Data link connector (DLC) (part of 14401) |
| 11 | - | Steering column opening lower finish panel reinforcement |
| 12 | - | DLC screw (2 required) |
| 13 | - | Electrical connector (part of 14401) |
| 14 | - | Ignition switch lock cylinder |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.