Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1183 (ENGINE SYSTEM - GENERAL INFORMATION)DIAGNOSTIC TESTSENGINEINSPECTION AND VERIFICATION - ENGINE PERFORMANCE
2009 Mercury Milan Premier, 3.0 1, AWD
Inspection and Verification - Engine Performance
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Inspection and Verification - Engine Performance
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern by operating the engine to duplicate the condition.
- Visually inspect for obvious signs of mechanical damage. Refer to the following chart.VISUAL INSPECTION CHART
Mechanical - Engine coolant leaks
- Engine oil leaks
- Fuel leaks
- Damaged or severely worn parts
- Loose mounting bolts, studs and nuts
- If the inspection reveals obvious concerns that can be readily identified, repair as necessary.
- If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
- If the scan tool does not communicate with the VCM:
- check the VCM connection to the vehicle.
- check the scan tool connection to the VCM.
- refer to MODULE COMMUNICATIONS NETWORK article, No Power To The Scan Tool, to diagnose no communication with the scan tool.
- If the scan tool does not communicate with the vehicle:
- verify the ignition key is in the ON position.
- verify the scan tool operation with a known good vehicle.
- refer to MODULE COMMUNICATIONS NETWORK article to diagnose no response from the PCM.
- Carry out the network test.
- If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK article.
- If the network test passes, retrieve and record continuous memory DTCs.
- Clear the continuous DTCs and carry out the self-test diagnostics for the PCM.
- If the DTCs retrieved are related to the concern, refer to MULTIFUNCTION ELECTRONIC MODULES article.
- If no DTCs related to the concern are retrieved, go to Symptom Chart - Engine Performance .
NOTE:
Make sure to use the latest scan tool software release.
NOTE:
The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the VCM DLC are provided to the VCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.