Torque Specifications

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Camshaft position (CMP) sensor bolt 10 - 89
Catalyst monitor sensor 48 35 -
Crankshaft position (CKP) sensor bolt 10 - 89
Fuel rail pressure and temperature sensor bolts 4 - 35
Heated oxygen sensor (HO2S) 48 35 -
Idle air control (IAC) valve bolts 10 - 89
LH splash shield bolts 10 - 89
Mass air flow (MAF) sensor 2 - 18
Powertrain control module (PCM) stud bolts and nuts 9 - 80
RH splash shield bolts 9 - 80
Throttle position (TP) sensor screws 3 - 27
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.