Instrument Panel Air Distribution Ducts: Notes

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Notes
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Instrument Panel Air Distribution Ducts Components (1 Of 2)
GF0042614Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W710147 Front display interface module (FDIM) screw (4 required)
2 10D885 FDIM
3 - FDIM electrical connector (part of 14401)
4 W710506 Glove compartment screw (3 required)
5 7806024 Glove compartment
6 W710506 Glove compartment latch striker screw
7 7806064 Glove compartment latch striker
8 W705093 Lower center instrument panel trim screw
9 W710506 Lower steering column opening instrument panel trim screws
10 W710506 Instrument cluster opening instrument panel trim screw (2 required)
11 W707628 Instrument panel trim-to-audio unit bracket screw (4 required)
12 W701152 Instrument panel trim-to-audio unit bracket nut (2 required)
Fig 2: Instrument Panel Air Distribution Ducts Components (2 Of 2)
GF0042615Courtesy of FORD MOTOR CO.
Item Part Number Description
13 W706473 Defroster duct adapter screw (4 required)
14 19C580 Defroster duct adapter
15 W706473 Upper corner instrument panel trim screw (2 required)
16 W706473 Instrument panel support-to-defroster duct screw (2 required)
17 W710506 Lower corner instrument panel trim screw (2 required)
18 - Message center switch electrical connector (part of 14401)
19 - Headlamp switch electrical connector (part of 14401)
20 W710506 LH instrument panel duct assembly screw (4 required)
21 19B680 LH instrument panel duct assembly
22 W710506 RH instrument panel duct assembly screw (4 required)
23 19B680 RH instrument panel duct assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.