Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1049 (ENGINE IGNITION)REMOVAL AND INSTALLATIONENGINE IGNITION COMPONENTS - EXPLODED VIEW
2009 Mercury Milan Premier, 3.0 1, AWD
Engine Ignition Components - Exploded View
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Engine Ignition Components - Exploded View
WARNING: This page is about a different car, the 2008 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 6758 | Crankcase vent tube-to-valve cover fitting quick connect coupling |
| 2 | - | Ignition coil-on-plug electrical connector (3 required) (part of 12A581) |
| 3 | W708833 | Ignition coil-on-plug bolt (3 required) |
| 4 | 12A375 | Ignition coil-on-plug (3 required) |
| 5 | 12405 | Spark plug (3 required) |
| 6 | 12A384 | Coil seal (3 required) |
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Ignition coil-on-plug electrical connector (3 required) (part of 12A581) |
| 2 | W708833 | Ignition coil-on-plug bolt (3 required) |
| 3 | 12A375 | Ignition coil-on-plug (3 required) |
| 4 | 12405 | Spark plug (3 required) |
| 5 | 12A384 | Coil seal (3 required) |
- For additional information, refer to the procedures.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.