Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1033 (ENGINE - 2.3L)IN-VEHICLE SERVICINGVALVE SEALSINSTALLATION

2009 Mercury Milan Premier, 3.0 1, AWD

Valve Seals: Installation

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation

WARNING: This page is about a different car, the 2008 Mercury Milan and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Install the valve stem seal installation sleeve.

Fig 1: Identifying Valve Stem Seal Installation Sleeve

GF0008947

Courtesy of FORD MOTOR CO.

Using the Valve Stem Oil Seal Installer, install the valve seal.

Fig 2: Installing Valve Seal Using Special Tool (303-470)

GF0008948

Courtesy of FORD MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.