Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1033 (ENGINE - 2.3L)DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIESCYLINDER HEADASSEMBLY
2009 Mercury Milan Premier, 3.0 1, AWD
Cylinder Head: Assembly
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Assembly
WARNING: This page is about a different car, the 2008 Mercury Milan and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Install the valves.
- Using the Valve Stem Oil Seal Installer, install the valve seals.
NOTE:
Coat the valve stems with clean engine oil.
NOTE:
Use the protector provided with the replacement kit to prevent damage to the valve seals. Lubricate the valve stems and guides with clean engine oil.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.