Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN AWD L4-2.3LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - ACCESSORIES AND OPTIONAL EQUIPMENTPARKING ASSIST CONTROL MODULESERVICE AND REPAIR
2009 Mercury Milan AWD L4-2.3L
Parking Assist Control Module: Service and Repair
2009 Mercury Milan AWD L4-2.3LSECTION Service and Repair
Parking Aid Module (PAM)
Removal and Installation
1. Remove the LH interior C-pillar trim panel.
2. Remove the LH rear seat bolster.
3. Remove the 2 screws and the Parking Aid Module (PAM).
- Disconnect the PAM electrical connectors.
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.