Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2006MARINER 4WD V6-3.0L VIN 1REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSTESTING AND INSPECTIONINITIAL INSPECTION AND DIAGNOSTIC OVERVIEWPROVE OUT PROCEDURE
2006 Mercury Mariner 4WD V6-3.0L VIN 1
Prove Out Procedure
2006 Mercury Mariner 4WD V6-3.0L VIN 1SECTION Prove Out Procedure
PROVE OUT PROCEDURE
Turn the ignition switch from the OFF to the ON position and visually monitor the air bag indicator with all SRS components connected or restraint system diagnostic tools installed. The air bag indicator will light continuously for approximately 6 seconds and then turn off. If an SRS fault is present, the air bag indicator will:
- fail to light.
- remain lit continuously.
- flash.
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and an SRS fault exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator will need to be repaired before diagnosis can continue.
Turn the ignition switch from the OFF to the ON position and visually monitor the air bag indicator with all SRS components connected or restraint system diagnostic tools installed. The air bag indicator will light continuously for approximately 6 seconds and then turn off. If an SRS fault is present, the air bag indicator will:
- fail to light.
- remain lit continuously.
- flash.
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and an SRS fault exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator will need to be repaired before diagnosis can continue.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.