Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2005SABLE V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIR
2005 Mercury Sable V6-3.0L DOHC VIN S
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
2005 Mercury Sable V6-3.0L DOHC VIN SSECTION Service and Repair
ENGINE COOLANT TEMPERATURE (ECT) SENSOR
Removal and Installation
1. Drain the cooling system.
2. Remove the air cleaner assembly.
3. Remove the battery tray.
4. NOTE: Engine shown partially disassembled for clarity.
Disconnect the engine coolant temperature (ECT) sensor electrical connector.
5. Remove the ECT sensor.
- Pull upward on the locking tab.
- Rotate the sensor counterclockwise and remove.
6. To install, reverse the removal procedure.
Removal and Installation
1. Drain the cooling system.
2. Remove the air cleaner assembly.
3. Remove the battery tray.
4. NOTE: Engine shown partially disassembled for clarity.
Disconnect the engine coolant temperature (ECT) sensor electrical connector.
5. Remove the ECT sensor.
- Pull upward on the locking tab.
- Rotate the sensor counterclockwise and remove.
6. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.