Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Left Power Seat Switch
Remove left power seat switch. Using ohmmeter, measure resistance between indicated switch terminals when switch is activated as specified. See LEFT POWER SEAT SWITCH RESISTANCE table. See Figure . Replace switch if it does not test as specified.
| Switch Position | Measure Between Terminals No. | Ohms | |
|---|---|---|---|
| Forward/Rearward | |||
| Forward | 1 & 6; 2 & 3 | Less Than 5 | |
| Rest | All | Greater Than 5 | |
| Rearward | 1 & 3; 2 & 6 | Less Than 5 | |
| Front Height | |||
| Up | 3 & 4; 5 & 6 | Less Than 5 | |
| Rest | All | Greater than 5 | |
| Down | 3 & 5; 4 & 6 | Less Than 5 | |
| Recline | |||
| Up | 3 & 8; 6 & 7 | Less Than 5 | |
| Rest | All | Greater than 5 | |
| Down | 3 & 7; 6 & 8 | Less Than 5 | |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.