Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2001SABLE LS, 4D SEDAN, 3.0 U, AX4SREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM CONTROLBLEEDING BRAKE SYSTEMBRAKELINESPRESSURE BLEEDING
2001 Mercury Sable LS, 4D Sedan, 3.0 U, AX4S
Pressure Bleeding
2001 Mercury Sable LS, 4D Sedan, 3.0 U, AX4SSECTION Pressure Bleeding
- Clean reservoir cap area. Connect pressure bleeder. Remove dust cap from right rear wheel bleeder fitting. Attach hose to bleeder fitting. Submerge other end of hose in container of clean brake fluid.
- Open valve on bleeder tank to pressurize system. Maintain system pressure at less than 50 psi (3.5 kg/cm2 ). With brake pedal released, open bleeder fitting until air bubbles no longer emerge from submerged end of hose.
- Repeat procedure at left rear, right front and left front wheels. When complete, close pressure bleeder tank valve, remove adapter and adjust fluid level to .16" (4.1 mm) below MAX line.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.