SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2001SABLE LS, 4D SEDAN, 3.0 U, AX4SREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESFORD MOTOR CO.INSTRUMENT CLUSTER PROGRAMMINGINSTRUMENT CLUSTER PROGRAMMING PROCEDURE "C"
2001 Mercury Sable LS, 4D Sedan, 3.0 U, AX4S

Instrument Cluster Programming Procedure "C"

2001 Mercury Sable LS, 4D Sedan, 3.0 U, AX4SSECTION Instrument Cluster Programming Procedure "C"
NOTE: After Hybrid Electronic Instrument Cluster (HEC) has been replaced, PCM ID MUST be reset and Passive Anti-Theft System (PATS) parameter reset procedure MUST be performed. See SECURITY ACCESS PROCEDURE .

Perform security access for instrument cluster. See SECURITY ACCESS PROCEDURE . Using NGS tester, select PARAMETER RESET command for instrument cluster. Using NGS tester, select PARAMETER RESET command for PCM. Disconnect negative battery cable and wait 3 minutes for PCM Keep Alive Memory (KAM) to clear. Reconnect negative battery cable. Cycle ignition switch from OFF to ON position using 2 encoded ignition keys. Both PATS keys and PCM ID should be set in instrument cluster.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.