Remote Keyless Entry (RKE) Transmitter Programming: Villager

2000 Mercury Mystique GS, 2.0 3, AutomaticSECTION Villager
  1. While inside of vehicle, close and lock all doors. Insert and remove key in ignition switch 6 times within 10 seconds. Parking lights will flash 2 times to confirm programming mode has been entered. Turn ignition switch to ACC position.
  2. Press any button on remote transmitter to be programmed. Parking lights will flash 2 times to confirm remote transmitter has been programmed. To program additional remote transmitters, unlock then lock driver's door at driver's door lock switch. Press any button on additional remote transmitter(s) to be programmed. Parking lights will flash 2 times to confirm remote transmitter has been programmed. Open driver's door to exit programming mode.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.