Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Remote Keyless Entry (RKE) Transmitter Programming: Focus
Turn ignition switch to accessory position. When clock LED illuminates, turn ignition off and remove key. Press and hold either button on remote transmitter until LED on remote transmitter flashes 5 times. While still holding button down, press other button 3 times. Release both buttons. To program additional transmitters, repeat button pressing for each transmitter. To exit learning mode, turn ignition switch to RUN position then to OFF position. After 20 seconds, system will exit learning mode. Check all transmitters.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.