SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2000MYSTIQUE GS, 2.0 3, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESRELEARN PROCEDURESREMOTE KEYLESS ENTRY (RKE) TRANSMITTER PROGRAMMINGEXPLORER & MOUNTAINEER
2000 Mercury Mystique GS, 2.0 3, Automatic

Explorer & Mountaineer

2000 Mercury Mystique GS, 2.0 3, AutomaticSECTION Explorer & Mountaineer

Cycle ignition switch from OFF to RUN position 8 times ending in RUN position within 10 seconds to enter program mode. Doors should lock and unlock to confirm program mode has been entered. Press any button on transmitter(s). Doors will lock, then unlock to confirm programming. If equipped with memory seats, ensure transmitter(s) are programmed in order according to numbers on back of transmitter(s). Turn ignition off and wait 5 minutes for system to exit program mode.

NOTE: After first remote transmitter is programmed, all other remote transmitters will be erased from memory. All remote transmitters must be programmed at the same time.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.