Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2000MYSTIQUE GS, 2.0 3, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESRELEARN PROCEDURESREMOTE KEYLESS ENTRY (RKE) TRANSMITTER PROGRAMMINGCONTOUR & MYSTIQUE
2000 Mercury Mystique GS, 2.0 3, Automatic
Contour & Mystique
2000 Mercury Mystique GS, 2.0 3, AutomaticSECTION Contour & Mystique
- Turn ignition switch to RUN position. Locate programming connector located next to electronic door lock module above glove box. Momentarily connect both terminals on programming connector. Horn will sound to verify program mode has been entered successfully. Press any button on remote transmitter.
- Horn will sound again to verify remote transmitter has been programmed successfully. To program additional remote transmitters, press any button on next remote transmitter. Horn will sound again to indicate new transmitters have been programmed. Turn ignition switch to LOCK position. Horn will sound again to confirm program mode has exited.
NOTE:
After first remote transmitter is programmed, all other remote transmitters will be erased from memory. All remote transmitters must be programmed at the same time. Up to 4 transmitters may be programmed at one time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.