Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmitter Programming
Locate programming 2-pin connector, behind glove box, near central locking module. Turn ignition switch to RUN position. Momentarily jumper 2-pin connector. Horn should sound to confirm program mode activation. Press any button on transmitter. Horn should sound to confirm transmitter code was received. For each additional transmitter, press any button to add. After all transmitters have been programmed, turn ignition off. Horn will sound once again to confirm program mode exit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.