Generic Misfire Processing

The acceleration that a piston undergoes during a normal firing event is directly related to the amount of torque that cylinder produces. The calculated piston/cylinder acceleration value(s) are compared to a misfire threshold that is continuously adjusted based on inferred engine torque. Deviant accelerations exceeding the threshold are conditionally labeled as misfires.

The calculated deviant acceleration value(s) are also evaluated for noise. Normally, misfire results in a nonsymmetrical loss of cylinder acceleration. Mechanical noise, such as rough roads at high RPM with light load conditions, will produce symmetrical acceleration variations. Cylinder events that indicate excessive deviant accelerations of this type are considered noise. Noise-free deviant acceleration exceeding a given threshold is labeled a misfire.

The number of misfires are counted over a continuous 200 revolution and 1,000 revolution period. The revolution counters are not reset if the misfire monitor is temporarily disabled such as for negative torque mode. At the end of the evaluation period, the total misfire rate and the misfire rate for each individual cylinder is computed. The misfire rate is evaluated every 200 revolution period (Type A) and compared to a threshold value achieved from an engine speed/load table. This misfire threshold is designed to prevent damage to the catalyst due to sustained excessive temperature 899°C (1,650°F) for Pt/Pd/Rh advanced washcoat and 982°C (1,800°F) for Pd-only high tech washcoat. If the misfire threshold is exceeded and the catalyst temperature model calculates a catalyst mid-bed temperature that exceeds the catalyst damage threshold, the MIL blinks at a 1 Hz rate while the misfire is present. If the threshold is again exceeded on a subsequent driving cycle, the MIL is illuminated.

If a single cylinder is determined to be consistently misfiring in excess of the catalyst damage criteria, the fuel injector to that cylinder is shut off to prevent catalyst damage for a calibrated period of time, typically 30 to 60 seconds. Up to 2 cylinders may be disabled at the same time on 6 and 8 cylinder engines and one cylinder on 4 cylinder engines. After the calibrated period of time has elapsed, the injector is re-enabled. If misfire on that cylinder is detected again after 200 revolutions (about 5 to 10 seconds), the fuel injector is shut off again and the process repeats until the misfire is no longer present. Note that ignition coil primary circuit failures trigger the same type of fuel injector disablement. For additional information, refer to COMPREHENSIVE COMPONENT MONITOR (CCM) .

The misfire rate is also evaluated every 1,000 revolution period and compared to a single (type B) threshold value to indicate an emission-threshold concern, which can be either a single 1,000 over-rev event from startup or 4 subsequent 1,000 over-rev events on a drive cycle after start-up. Many vehicles set DTC P0316 if the type B threshold is exceeded during the first 1,000 revolutions after engine startup. This DTC is stored in addition to the normal P03xx DTC that indicates the misfiring cylinder. If the misfire is detected but it can not be attributed to a specific cylinder, DTC P0300 is stored.