Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1999SABLE V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSTESTING AND INSPECTIONPINPOINT TESTSBEFORE PINPOINT TESTSAX4S
1999 Mercury Sable V6-3.0L DOHC VIN S
AX4S
1999 Mercury Sable V6-3.0L DOHC VIN SSECTION AX4S
If DTCs appear while performing the self-test, refer to the On-Board Diagnostic Trouble Code Description Chart for the appropriate service procedure.
NOTE: Prior to entering pinpoint tests, refer to the TSBs for AX4S concerns.
NOTE: Prior to entering pinpoint tests, the vehicle harness must be checked for continuity and shorts and the PCM must be checked for any concerns.
NOTE: If any non-transaxle DTCs appear, service those DTCs first. They could affect the electrical operation of the transaxle. Record and erase codes from continuous memory after repairs have been performed. After servicing any DTCs in the Quick Test, the (Quick Test should be repeated.
NOTE: Check the PCM system wiring harness for proper connection, bent or broken pins, corrosion, loose wires, proper routing, proper seals and their condition. Check the PCM sensors and actuators for physical damage.
NOTE: Prior to entering pinpoint tests, refer to the TSBs for AX4S concerns.
NOTE: Prior to entering pinpoint tests, the vehicle harness must be checked for continuity and shorts and the PCM must be checked for any concerns.
NOTE: If any non-transaxle DTCs appear, service those DTCs first. They could affect the electrical operation of the transaxle. Record and erase codes from continuous memory after repairs have been performed. After servicing any DTCs in the Quick Test, the (Quick Test should be repeated.
NOTE: Check the PCM system wiring harness for proper connection, bent or broken pins, corrosion, loose wires, proper routing, proper seals and their condition. Check the PCM sensors and actuators for physical damage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.