Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1999SABLE LS, 4D SEDAN, 3.0 SREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSSHIFT INTERLOCK SYSTEMSREMOVAL & INSTALLATIONGEARSHIFT LEVER ASSEMBLYREMOVAL & INSTALLATION (CONTOUR, COUGAR & MYSTIQUE)
1999 Mercury Sable LS, 4D Sedan, 3.0 S
Removal & Installation (Contour, Cougar & Mystique)
1999 Mercury Sable LS, 4D Sedan, 3.0 SSECTION Removal & Installation (Contour, Cougar & Mystique)
- Raise and support vehicle. Remove lower heat shield covering access to gearshift lever mounting bolts. Disconnect gearshift lever cable adjusting cap and gearshift lever cable. Remove 4 gearshift lever mounting nuts.
- Lower vehicle. Remove gearshift lever cover. Lift gearshift lever assembly upwards and disconnect gearshift lever electrical connector. To install, reverse removal procedure. Tighten nuts to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.