Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1998VILLAGER GS, VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSGENERATORSPECIFICATIONSGENERAL SPECIFICATIONS
1998 Mercury Villager GS, Van Cargo
General Specifications
1998 Mercury Villager GS, Van CargoSECTION General Specifications
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Type | A3TA1091ZC |
| Nominal Rating | 12V - 110A |
| Ground Polarity | Negative |
| Mininum Revolution Under No - Load (When 13.5 volts is applied) | 1.300 rpm |
| Hot Output current | More than 33A/1.300 rpm.More than 85A/2.500 rpm |
| Regulated Output Voltage | 14.1-14.7V |
| Minimum Length of Brush | 8.0mm (0.315 inch) |
| Brush Spring Pressure | 3.138-4.315 N (11.29-15.52 oz.) |
| Slip Spring Minimum Outer Diameter | 22.1mm (0.870 inch) |
| Rotor (Field Coil) Resistance | 2.3-2.7 ohms |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.