Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1998MOUNTAINEER 5.0 P, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 61 (ENGINE CONTROLS SELF-DIAGNOSTICS - EEC-V - CNG & GASOLINE - INTRODUCTION, SELF-DIAGNOSTIC SYSTEM, ADDITIONAL SYSTEM FUNCTIONS, PROGRAMMING PCM, DIAGNOSTIC TROUBLE CODE DEFINITIONS, HOW TO USE SYSTEM TESTS)ADDITIONAL SYSTEM FUNCTIONSPARAMETER IDENTIFICATION MODEACCESSING GENERIC OBD-II PIDS
1998 Mercury Mountaineer 5.0 P, AWD
Accessing Generic OBD-II PIDs
1998 Mercury Mountaineer 5.0 P, AWDSECTION Accessing Generic OBD-II PIDs
WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2001 Mercury Sable, 2001 Mercury Mountaineer, 2001 Mercury Grand Marquis, 2001 Mercury Cougar, and 2001 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tool using the following steps:
- Select VEHICLE & ENGINE SELECTION menu.
- Select NEW VEHICLE, YEAR & MODEL.
- Select GENERIC OBD-II OPTIONS. Press CONT button if monitors are not complete.
- Select PID/DATA MONITOR & RECORD.
- Turn ignition switch to ON position or start engine and allow to idle.
- Follow operating instructions from scan tool menu.
- Select PIDs and press START to begin monitoring. If PID value is not as specified, perform appropriate SYSTEM TEST.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.