Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmitter Programming
Open driver's window. Cycle ignition key from LOCK to RUN 8 times within 10 seconds ending in RUN position. Doors will lock, then unlock to verify program mode has been entered. Within 20 seconds, press any button on transmitter. Doors will lock, then unlock to confirm transmitter has been programmed. Turn ignition switch to LOCK position or wait 20 seconds to exit program mode. Doors will lock, then unlock to confirm program mode has been exited.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.