Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmitter Programming
Open driver's window. Turn ignition switch from LOCK to RUN position 4 times within 3 seconds ending in RUN position. Door locks will lock then unlock to verify programming mode has been entered. Press any button on transmitter to be programmed. Within 7.5 seconds, press any button on next transmitter to be programmed and so on until all transmitters are programmed. To exit programming mode, turn ignition switch to START position or wait for more than 7.5 seconds.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.