Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accessing Generic OBD-II PIDs
1998 Mercury Mountaineer 5.0 P, AWDSECTION Accessing Generic OBD-II PIDs
Turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:
- Select VEHICLE & ENGINE SELECTION menu.
- Select NEW VEHICLE, YEAR & MODEL.
- Select GENERIC OBD-II OPTIONS. Press CONT button if monitors are not complete.
- Select PID/DATA MONITOR.
- Turn ignition on or start engine and allow to idle.
- Follow operating instructions from scan tool menu.
- Select PIDs and press START to begin monitoring. If PID value is not as specified, perform appropriate CIRCUIT TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.