Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Coil Spring & Strut Assembly: Disassembly
Using a spring compressor, compress strut spring enough to relieve initial tension. Place a box-end wrench on top of strut shaft and hold while removing top shaft nut using a 6-point crowfoot wrench and ratchet. See Fig 1 . Compress strut spring more if necessary. Remove strut shaft nut. Slowly loosen spring compressor and remove top mount bracket assembly, bearing plate assembly and spring. See Fig 2 .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.