Disabling System

1996 Mercury Sable GS, 4D Wagon, AX4NSECTION Disabling System
WARNING: This page is about a different car, the 1997 Mercury Sable and 1997 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Following disabling procedure should be used for component replacement purposes only. If vehicle was involved in a collision and air bag did not deploy or if SRS is not functioning properly, and vehicle needs to be driven, complete system deactivation is required. See COMPLETE SYSTEM DEACTIVATIONΒ  .

Disconnect negative and then positive battery cables. Shield both cables. SRS contains a back-up power supply built into air bag diagnostic monitor. Wait at least one minute before servicing any air bag components. System is now disabled. To activate SRS, see ACTIVATING SYSTEMΒ  .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.