Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1996SABLE GS, 4D WAGON, AX4NREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES)WHEEL ALIGNMENT PROCEDURESTOE-IN ADJUSTMENT (REAR)SABLE & TAURUS
1996 Mercury Sable GS, 4D Wagon, AX4N
Sable & Taurus
1996 Mercury Sable GS, 4D Wagon, AX4NSECTION Sable & Taurus
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 1999 Mercury Tracer, 1999 Mercury Sable, 1999 Mercury Mystique, 1999 Mercury Grand Marquis, and 1999 Mercury Cougar. However, it is still accessible from the selected car via links, so may be relevant.
Loosen front lower control arm-to-body retaining bolt. Rotate adjusting cam to obtain correct toe-in. While holding adjusting cam, tighten rear adjusting cam attaching nut. See Fig 1 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.