Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Identification
Engine may be identified by eighth character of Vehicle Identification Number (VIN). VIN is located on top of instrument panel, near lower left corner of windshield.
An emission calibration number is located on driver's door or door-post pillar. This label identifies engine calibration number, engine code and revision label.
Engine code label is located on valve cover. Label contains engine calibration number, engine build date, plant code and engine code. Information from labels are required when ordering replacement parts.
| Engine | Code |
|---|---|
| 3.8L MFI | 4 |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.