Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation (Villager)
Disconnect negative battery cable. Remove the instrument panel support. Position the heater duct assembly away from the Powertrain Control Module (PCM). Remove the PCM electrical connector bolt. Pull the connector from the PCM and position aside. Remove the two PCM bolts. Remove the PCM from behind the instrument panel. To install, reverse removal procedure. Tighten the PCM electrical connector bolt until the Red projection appears.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.