Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1995VILLAGER GS, VAN PASSENGERREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER SEATSREMOVAL & INSTALLATIONSEAT ASSEMBLYREMOVAL (DRIVER OR PASSENGER)
1995 Mercury Villager GS, Van Passenger
Removal (Driver Or Passenger)
1995 Mercury Villager GS, Van PassengerSECTION Removal (Driver Or Passenger)
- Disconnect battery ground cable. Remove under seat storage drawer. Move the front seat fully forward.
- Remove the rear 2 front seat track-to-front seat support assembly bolts. See Fig 1 .
- Move front seat fully forward. Remove 2 front seat track-to-front seat support assembly bolts. See Fig 2 .
- Disconnect seat regulator control switch or seat back control switch connector under front seat adjuster. See Fig 3 .
- Slide front safety belt retractor and tongue out of front seat cushion side shield. Remove front seat and front seat track assembly from vehicle.
- Remove the front seat support assembly from the vehicle.
NOTE:
Front seat and front seat track assembly is removed separately from front seat support assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.