Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1994CAPRI XR2, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSAIR BAG RESTRAINT SYSTEMREMOVAL & INSTALLATIONREAR SAFING SENSORINSTALLATION
1994 Mercury Capri XR2, Automatic
Rear SAFING Sensor: Installation
1994 Mercury Capri XR2, AutomaticSECTION Installation
- Connect sensor wiring connector to harness. Position sensor to bracket, with sensor top arrow facing toward front of vehicle. Install retaining bolt and screw, and tighten to specification. See TORQUE SPECIFICATIONS at the end of this article.
- To complete installation, reverse removal procedure. Activate SRS. Check AIR BAG light to ensure system is functioning properly. See TESTING - SYSTEM OPERATION CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.