Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
1993 Mercury Villager GS, Van Passenger
Power Seats
1993 Mercury Villager GS, Van PassengerSECTION Power Seats
- Description & Operation
- Component Locations
- Trouble Shooting
- Preliminary Inspection
- Power Seats Do Not Work
- Driver Power Seat Does Not Operate
- Driver Power Seat Forward/Reverse Sliding Operation Does Not Work
- Driver Power Seat Up/Down Lifting Operation Does Not Work
- Driver Power Seat Up/Down Reclining Operation Does Not Work
- Passenger Power Seat Does Not Operate
- Passenger Power Seat Forward/Reverse Sliding Operation Does Not Work
- Passenger Power Seat Up/Down Reclining Operation Does Not Work
- Power Lumbar Support Does Not Work
- Air Will Not Fill Lumbar Support Bag
- Air Fills Lumbar Support Bag But Air Pressure Will Not Hold
- Air Will Not Release From Lumbar Support Bag
- System Tests
- Power Seat System
- PS1: Check Fuse
- PS2: Check System
- PS3: Check for Short(s) To ground
- PS4: Check Power Supply To Driver Power Seat Switch
- PS5: Check Power Supply
- PS6: Check "R"- "W/R" Wire
- PS7: Check Ground At Driver Power Seat Switch
- PS8:Check Driver Power Seat Switch
- PS9: Check Driver Motor Assembly
- PS10: Check Power Supply To Passenger Power Seat Switch
- PS11: Check Ground At Passenger Power Seat Switch
- PS12:Check Passenger Power Seat Switch
- PS13: Check Passenger Motor Assembly
- PS14:Check Power Supply To Lumbar Support Switch
- PS15: Check Ground At Lumbar Support Motor
- PS16: Check Lumbar Support Motor
- PS17: Check Lumbar Support Switch
- Power Seat System
- Removal & Installation
- Torque Specifications
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.