Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1993SABLE GS, 4D SEDAN, 3.0 U, AXODEREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSOVERHAUL - AX4S/AXOD-ECOMPONENT DISASSEMBLY & REASSEMBLYOIL PUMPREMOVAL & INSTALLATION
1993 Mercury Sable GS, 4D Sedan, 3.0 U, AXODE
Removal & Installation
1993 Mercury Sable GS, 4D Sedan, 3.0 U, AXODESECTION Removal & Installation
- To separate oil pump housing from valve body, remove Torx bolts retaining oil pump housing to valve body. See Fig 1 . Separate valve body from oil pump. Remove and discard gasket. Clean gasket surface thoroughly.
- Prior to installing oil pump housing to valve body, ensure check balls and relief valves are in correct position in pump housing. Position a new gasket and separator plate on oil pump housing.
- Insert valve body Guide Pin Set (T86P-70100 "A" and "B") in valve body. See Fig 1 . Install 2 Torx bolts retaining separator plate to oil pump housing. Install pump housing on valve body.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.