Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Symptoms Diagnosis
Symptom checks cannot be used properly unless problem occurs while vehicle is being tested. To reduce diagnostic time, ensure steps in BASIC TESTING and G - EEC-IV TESTS W/CODES articles in the ENGINE PERFORMANCE Section were performed before diagnosing a symptom. Symptom checks are listed in order of probability, ease of accomplishment, and accessibility. Symptoms available for diagnosis are as follows.
- No Crank
- Hard Start/Long Crank
- Stalls After Start
- No Start/Normal Crank
- Slow Return To Idle
- Rough Idle
- High Idle (Diesels/Runs On)
- Low Idle (Stalls On Deceleration)
- Hesitates Or Stalls
- Surge (On Acceleration Or Cruise)
- Backfires
- Loss Of Power
- Spark Knock
- Poor Fuel Economy
- Emissions Compliance
- Warning Indicator Lights
- Improper Transmission Shift
- High Oil Consumption
- Engine Runs Hot
- Engine Runs Cold
- Exhaust Smoke
- Gas Smell
- Engine Noise
- Vibration
- Climate Control (Lack Of Cooling)
- Climate Control (A/C Always On)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.