Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1991TRACER BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (ENGINE CONTROLS - SYSTEM/COMPONENT TESTS - EEC-IV)FUEL SYSTEMFUEL SYSTEM PRESSURE RELEASEEXCEPT 1.9L
1991 Mercury Tracer Base, 4D Sedan, Automatic
Except 1.9L
1991 Mercury Tracer Base, 4D Sedan, AutomaticSECTION Except 1.9L
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1993 Mercury Tracer, 1993 Mercury Topaz, 1993 Mercury Sable, 1993 Mercury Grand Marquis, and 1993 Mercury Cougar. However, it is still accessible from the selected car via links, so may be relevant.
- Remove fuel cap to release fuel tank pressure. Remove relief valve cap. Relief valve is located on fuel supply manifold. Using EFI Pressure Gauge (T80L-9974-B), release fuel pressure from relief valve (Schrader valve).
- If fuel pressure gauge is not available, disconnect electrical connector to inertia switch located on left side of luggage compartment. Crank engine for 15 seconds to reduce system pressure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.