SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1991TRACER BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL)IGNITION SYSTEMCAMSHAFT POSITION SENSORREMOVAL & INSTALLATION (1.9L)
1991 Mercury Tracer Base, 4D Sedan, Automatic

Removal & Installation (1.9L)

1991 Mercury Tracer Base, 4D Sedan, AutomaticSECTION Removal & Installation (1.9L)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1994 Mercury Tracer, 1994 Mercury Topaz, 1994 Mercury Sable, 1994 Mercury Grand Marquis, and 1994 Mercury Cougar. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Remove intake manifold. SeeREMOVAL & INSTALLATION in 1.9L 4-CYLINDER article in ENGINES. Remove CMP sensor mounting screws and CMP sensor from cylinder head. SeeFig 1. To install, replace "O" ring. Install CMP sensor and retaining screws. To complete installation, reverse removal procedure. Tighten CMP sensor screws to specification. See TORQUE SPECIFICATIONS .

Fig 1: Locating Camshaft Position Sensor (1.9L)
G00191834Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.