Removal (3.8L SC)

1991 Mercury Tracer Base, 4D Sedan, AutomaticSECTION Removal (3.8L SC)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1994 Mercury Tracer, 1994 Mercury Topaz, 1994 Mercury Sable, 1994 Mercury Grand Marquis, and 1994 Mercury Cougar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE. Disconnect negative battery cable. Remove charge air cooler tubes. See CHARGE AIR COOLER INLET TUBE and CHARGE AIR COOLER OUTLET TUBE.
  2. Remove supercharger assembly (including throttle body and adapter plenum. Remove fuel supply and return lines at fuel rail assembly. See FUEL LINE CONNECTOR. Remove wiring harness from fuel injectors. Remove fuel pressure regulator bolt. Disengage fuel injectors and remove fuel rail.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.