Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1991TRACER BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL)FUEL SYSTEMFUEL PUMPREMOVAL (ALL OTHERS)
1991 Mercury Tracer Base, 4D Sedan, Automatic
Removal (All Others)
1991 Mercury Tracer Base, 4D Sedan, AutomaticSECTION Removal (All Others)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1994 Mercury Tracer, 1994 Mercury Topaz, 1994 Mercury Sable, 1994 Mercury Grand Marquis, and 1994 Mercury Cougar. However, it is still accessible from the selected car via links, so may be relevant.
- Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE. Drain fuel from tank. Raise vehicle on hoist. Remove exhaust heat shield. Remove exhaust pipe (if necessary). Remove fuel inlet and return hoses.
- Disconnect vapor crossover and filler hoses. Support fuel tank. Remove fuel tank strap bolts. Partially lower fuel tank. Disconnect fuel lines and electrical connector from fuel gauge sender. Remove fuel tank.
- Remove any dirt from around fuel pump flange area. Using Fuel Tank Sender Wrench (D84P-9257-A), remove fuel pump locking ring. Remove fuel pump.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.