Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 146 (Air Bag Restraint System): Identification
All models are equipped with driver-side and passenger-side air bags and is identified by a letter "L" in the fourth position of the Vehicle Identification Number (VIN). The VIN is located on top of instrument panel, near lower left corner of windshield. The VIN is also stamped on Vehicle Certification (VC) label, mounted on left front door pillar.
The words Supplemental Restraint System or SRS is embossed on the steering wheel center hub and/or on the instrument panel above the glove box. A label denoting that vehicle is equipped with air bags is affixed to driver-side sun visor.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.