Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1991TRACER BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 113 (ENGINE CONTROLS - BASIC TESTING - 4.6L)FUEL SYSTEMINERTIA FUEL SHUTOFF (IFS) SWITCH
1991 Mercury Tracer Base, 4D Sedan, Automatic
Inertia Fuel Shutoff (Ifs) Switch
1991 Mercury Tracer Base, 4D Sedan, AutomaticSECTION Inertia Fuel Shutoff (Ifs) Switch
WARNING: This page is about a different car, the 1995 Lincoln Mark VIII. However, it is still accessible from the selected car via links, so may be relevant.
- If IFS switch is tripped, engine cannot be restarted until switch is manually reset. To reset IFS switch, depress switch button. For IFS switch location, see INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION table.INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION
Application Location Mark VIII In Trunk On Left Hinge Support Or Behind Trim Panel - To test IFS switch, turn ignition off. Remove IFS switch. Shake IFS switch to force it into tripped position (switch open). Check continuity between appropriate IFS switch terminals. See the WIRING DIAGRAMS article in the ENGINE PERFORMANCE section. Continuity should not exists. Reset switch and ensure continuity exists between appropriate terminals.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.