Fuel Pressure Release

1991 Mercury Tracer Base, 4D Sedan, AutomaticSECTION Fuel Pressure Release
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1995 Mercury Grand Marquis, 1995 Mercury Cougar, 1995 Lincoln Town Car, 1995 Lincoln Continental, and 1995 Ford Thunderbird. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove fuel cap to release fuel tank pressure. Remove relief valve cap. Relief valve (service port) is located on fuel supply manifold. Using Fuel Pressure Gauge (T80L-9974-B), release fuel pressure from relief valve (Schrader valve).
  2. If fuel pressure gauge is not available, disconnect electrical connector to IFS switch. For IFS switch location, see INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION table under INERTIA FUEL SHUTOFF (IFS) SWITCH. Crank engine for 15 seconds to reduce system pressure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.