Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1991TRACER BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 100 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL - 4.6L)FUEL SYSTEMFUEL SYSTEM PRESSURE RELEASE
1991 Mercury Tracer Base, 4D Sedan, Automatic
Fuel System Pressure Release
1991 Mercury Tracer Base, 4D Sedan, AutomaticSECTION Fuel System Pressure Release
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Mercury Grand Marquis, 1995 Mercury Cougar, 1995 Lincoln Town Car, 1995 Lincoln Mark VIII, and 1995 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
ALWAYS relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components.
- Remove fuel cap to release fuel tank pressure. Remove relief valve cap. Relief valve is located on fuel supply manifold. Using Fuel Pressure Gauge (T80L-9974-B), release fuel pressure from relief valve (Schrader valve).
- If fuel pressure gauge is not available, disconnect electrical connector to IFS switch. For IFS switch location, see INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION table. Crank engine for 15 seconds to reduce system pressure. Turn ignition off. Reconnect IFS switch connector.
INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION
| Application | Location |
|---|---|
| All Models | In Trunk On Left Hinge Support Or Behind Trim Panel |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.