Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Description & Operation: Wiper/Washer
The wiper system consists of a wiper motor, relay and switch. The motor is located in the engine compartment, on driver-side bulkhead. The relay, which provides intermittent wiper function, is located under the driver-side dash panel.
The multifunction wiper/washer switch, mounted on the right of the steering column, has 4 positions: OFF, INT, I and II. Pushing the switch down activates MIST function, which cycles the wipers once to clear the windshield of light moisture. Pulling the switch back activates the washer system.
The INT position cycles the wipers intermittently every 15-20 seconds to maintain visibility in light rain. A variable speed intermittent system, which provides adjustable wipe cycle frequency, is also available as an option.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.